TheRcModelBoatForum.com
Please login using your username and password to use the forum.

If you do not have an account please register to participate, it’s free!

TheRcModelBoatForum.com

A Forum For Modelers By Modelers.
 
HomeHome  PortalPortal  RegisterRegister  Log inLog in  
Share
 

 Models by Design Puffer

Go down 
AuthorMessage
Fred 1948
Able Seaman
Able Seaman
Fred 1948

Posts : 26
Join date : 2017-04-14
Age : 71
Location : East Sussex

Models by Design Puffer Empty
PostSubject: Models by Design Puffer   Models by Design Puffer EmptySat Dec 07, 2019 1:51 pm

Hi One and All

With the sad loss of Models by Design and I wish them all the best in there retirement,( they have deserved it)

I have obtained one of there Puffer's but without any drawing's, now I seem to recall that it was based on the "Inchcolm"  (I do hope so) so I have placed an order for the drawing's from Sarik. the drawing's are at 1/32 and I think that the puffer is 1/24 would I have to reduce the drawing's by 75% to get the right scale??

Any help that you can give would be most welcome.

Fred
Back to top Go down
gribeauval
Master
Master
gribeauval

Posts : 484
Join date : 2011-06-11
Age : 68
Location : West Yorkshire

Models by Design Puffer Empty
PostSubject: Re: Models by Design Puffer   Models by Design Puffer EmptySat Dec 07, 2019 3:59 pm

The plans are a smaller scale than the hull scale so all the dimensions on the plan need to be made bigger by 133% not reduced.


Mike
Back to top Go down
Fred 1948
Able Seaman
Able Seaman
Fred 1948

Posts : 26
Join date : 2017-04-14
Age : 71
Location : East Sussex

Models by Design Puffer Empty
PostSubject: Size   Models by Design Puffer EmptySat Dec 07, 2019 7:19 pm

Hi Mike

Thank you for putting me right, some time after posting my comments I found my old conversion chart just wish I had found it before posting.

Fred
Back to top Go down
 
Models by Design Puffer
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
TheRcModelBoatForum.com :: General Modelling :: General Modelling Questions-
Jump to: