TheRcModelBoatForum.com
Please login using your username and password to use the forum.

If you do not have an account please register to participate, it’s free!
TheRcModelBoatForum.com
Would you like to react to this message? Create an account in a few clicks or log in to continue.


https://www.thercmodelboatforum.com/
 
HomeHome  RegisterRegister  Log inLog in  
 

 Have anyone done this on a lathe?

Go down 
AuthorMessage
Guest
Guest



Have anyone done this on a lathe? Empty
PostSubject: Have anyone done this on a lathe?   Have anyone done this on a lathe? EmptyMon May 11, 2015 7:14 am

Truly astonishing number of hours to produce.
A cube within a cube within a cube.
https://www.youtube.com/watch?v=AuS6HDHc7XE
Back to top Go down
LUQA
Deck Hand
Deck Hand
LUQA

Posts : 14
Join date : 2014-06-07
Age : 77
Location : Derby East Mids

Have anyone done this on a lathe? Empty
PostSubject: Lathe work   Have anyone done this on a lathe? EmptyMon May 11, 2015 7:08 pm

Hi there
            That is some great skill. I can remember watching a carver out in the far east in the sixties, they had skill, and the ability to see in to the future. 2thumbsup 2thumbsup cheers
                                       Regards Luqa
Back to top Go down
 
Have anyone done this on a lathe?
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
TheRcModelBoatForum.com :: The Lake Side :: At The Lake Side-
Jump to: